■  FEATURES
Designs for position control module QD75P.
Corresponding to position control terminal blocks S066 & S067. can realize a comprehensive connection between position control module and drive, then minimize the probability to connect cables in wrong way.

■  Cable Specifications

Gauger Specifications	AWG28
Wire Constitute	7/0.12MM²
Conductor material	软铜线
Insulation Material	PE
Twist and polishing	填允：棉线；包带；纸带
lolation	无
Appearance condition coating	PVC
Conductor impedance（ 20°C ）	239Ω/Kn 以下
Withstanding Voltage	AC500V/min
Insulation resistance	500MΩ/Kn 以上

■  Dimensions

Model		Cable specification	Dimensions	CN1		CN2		Lenght(mm)
L112-8		AWG 28		37P/MIL		40P/MIL		500～1000～1500 NOTES:the minimum cable is 500mm,and 500mm for increasing if need.
L112-9		AWG 28		37P/MIL		40P/MIL

·On the drawing, CN1 refers to PLC, CN2 refers to terminal Woa 
·Tolerance of overall length is ±30mm

■  Holes arrangement table

Model		Corresponding to CN1*¹						Corresponding to CN2			Notes
		Manufactures			PLC Module			Corresponding Terminal Blocks¹
L112-8		MITSUBISHI			QX81  QX81-S2			S011 S063			Utilizes external original
L112-9		MITSUBISHI			QY81P			S011  S063  SR32-PA1A-24  SE32-24			Utilizes Z+/-signal

*1 All ihe products mentioned on the table are owned by Company, and please refer to the comprehensive catalogue for the relative specifications of S series products.

■  Wiring Diagram 


■  Holes arrangement table

Please note:
The right arrangement table is the order standard of DLE, and different companies have different hole orders, please check it before use